ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Genre:||Health and Food|
|Published (Last):||28 October 2016|
|PDF File Size:||19.70 Mb|
|ePub File Size:||1.78 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. These sheets are made by rolling process.
ASTM B – 99() Standard Specification for Nickel Plate, Sheet, and Strip
Test methods chemical analysis, mechanical test, grain size test shall be performed in accordance to referenced ASTM documents itemized herein. AlloyAlloy Brand: In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the elimination of the anneal that follows hot rolling. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost.
Nickel /Nickel (UNS NO, UNS NO, ASTM B)
Siddhagiri Metals and Tubes Manufacturer: Siddhagiri Metals and Tubes Rating: Historical Version s – view previous versions of standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
This abstract is a brief summary of the referenced standard. Sheet and Strip can be cold rolled to higher strength.
Link to Active This link will always route to the current Active version of the standard. Aatm deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties. The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.
Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part. Offer on Fasteners Sitemap. Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and asstm.
ASTM B162 Alloy 200 / 201 Strip Plate and Sheet Suppliers
The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur. Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile and compressive conditions, without altering the sheet thickness.
Looking for some more information?